**BLEM** PMM SCAR 16/17 HD Rail Elimination Panels **BLEM**

THESE ARE MARKED AS BLEMS. THE COUNTER SINK WAS CUT TOO DEEP, SO THERE IS A SLIGHT BREAKTHROUGH OF THE ALUMINUM. THIS WILL NOT EFFECT INSTALLATION OR USE.

NO RETURNS ON BLEM PURCHASES.

Machined in-house out of T6-6061 aluminum, the PMM Rail Elimination Panels are a low profile and light weight solution to completely eliminate the factory rail sections on your SCAR 16 or 17 while still maintaining the use of the Captive Torx bolt on the front “horseshoe” receiver carrier on the SCAR 16/17.

Product Features:

• • 2x PMM Rail Elimination Panels Finished in either a Black or FDE 8625 type 3 class 2 industry standard hardcoat anodize.
  • Mounting hardware included.
  • Limited Lifetime Warranty.
  • Installation is simple using the factory intended 1913 Rail Mounting points on your SCAR.
  • Ergonomically designed Panels in either “SQUARE” or “ERGO” as well as “SMOOTH” or DIMPLED”
  • PMM Rail Elimination Panels install in minutes with no permanent weapon modification.
  • PMM Rail Elimination Panels will Work with any SCAR equipped with or without the PMM MRE or PRE Rail Extension
  • Ultra light weight/Low Profile design.
  • “SQUARE/DIMPLED” Panel Weighs .25oz      
  • “ERGO/DIMPLED” Panel Weighs .24oz
  • PMM Rail Elimination Panels sit only .060″ off the receiver once installed
  • Made in the USA